Brother 600 Scanner User Manual


 
12
This calibration process uses the special black and white calibration sheet (see picture
on page iv) that was included with your scanner. When calibrating, make sure the
side with the black bar is facing down and note the direction of the arrows for proper
insertion.
When the calibration process has been completed successfully, you will see the
message above; otherwise you will need to re-calibrate again.
If you switch scanners or your image quality has become unsatisfactory, you can
re-calibrate your scanner by choosing the CUSTOM button in the DSmobileSCAN
II
window and select the Calibrate button.
If you lose or forget the black and white calibration paper that was included with your
scanner, you can use any plain “White” (the brighter the “White” the better) piece
of letter size (or A4) printer paper to perform the calibration. Simply fold the
paper in half and insert the end opposite the fold into the scanner first when
calibrating. The following message will be displayed (see below).