Filter
Top Products
7 - 4
SETUP SEND
BHLMFC-US-MFC3100C-FM5.5
Color Fax Transmission
Your MFC allows you to transmit a color fax.
1
Place the original face down in the ADF.
2
Enter the fax number using the dial pad, Speed Dial or Search.
3
Press Color Fax Start.
Manual and Automatic Fax Redial
If you’re sending a fax manually and the line is busy, press Redial/Pause to
try again. Anytime you want to make a second call to the last number dialed,
press Redial/Pause to save time.
If you’re sending a fax automatically and the line is busy, the MFC will
automatically redial (up to three times at 5 minute intervals).
Dual Access (Not Available for Color Fax)
You can scan up to 50 documents into the fax memory, even while the machine
is receiving or sending another fax (from memory). You can set temporary
settings for each fax you’re scanning, except Polling.
If you try to scan and store a 51st fax, the MFC will send it immediately, without
storing it in memory.
1
Place the original face down in the ADF.
2
Enter the fax number.
3
Press Black Fax Start. The MFC scans the original and the LCD shows the
job number (#XXX) of the fax and how much memory is available. Then the
MFC starts dialing. You can immediately repeat Steps 1 to 3 for the next fax.
When you are sending a color fax, the MFC starts sending the fax without
scanning the original into memory.
Note
If you get a OUT OF MEMORY message while scanning the first page of a
fax, press Stop/Exit to cancel scanning. If you get a OUT OF MEMORY
message while scanning a subsequent page, you can press Black Fax Start to
transmit the pages scanned so far, or press Stop/Exit to cancel the operation.
Note
Your machine normally operates in Dual Access mode. However, to send a
color fax, you must override Dual Access and use Real Time Transmission.
The number of pages you can scan into memory varies with the data they
contain.