Filter
Top Products
115
INTERFACE
ERROR!
• This message appears if an
error occurs while data is
being sent from the computer
to the P-touch.
• Cancel the print job, and
then try printing again.
• This message appears if you
try to print when the baud
rates of the computer and the
P-touch are not the same.
• Cancel the print job, and
then select the same baud
rate for both the computer
and the P-touch.
LENGTH
LIMIT!
• This message appears if the
text is longer than 3’ 3 1/3” (1
meter) when you try to print.
• Shorten the text to less than
3’ 3 1/3” (1 meter) before try-
ing to print.
• This message appears if the
Length function is used to set
a label length that is less than
1.6 inches (4.0 cm) or more
than 11.8 inches (30.0 cm).
• Set the label length between
1.6 inches (4.0 cm) and 11.8
inches (30.0 cm).
• This message appears if the
Tab Length function is used
to set a tab length that is
more than 11.8 inches (30.0
cm).
• Set the tab length so that it is
less than 11.8 inches (30.0
cm).
LINE
LIMIT!
• This message appears if the
number of lines in the text is
greater than the maximum
number of lines possible for
the installed tape.
• Reduce the number of lines
or install a tape of greater
width.
MEMORY
FULL!
• This message appears if you
try to store a text file after
2500 characters have already
been stored in the memory.
• Delete an unwanted file to
make room for the new one.
NO
FILES!
• This message appears if you
try to recall or delete a text
file from the memory when
none are stored.
• Store a text file first.
Error Message Cause Solution