Filter
Top Products
76
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The fuser unit is too hot.
Jam Duplex The paper is jammed in the
duplex tray.
(See Paper jams on page 80.)
Jam Rear The paper is jammed in the back
of the machine.
(See Paper jams on page 80.)
Jam Inside The paper is jammed inside the
machine.
(See Paper jams on page 80.)
Jam MP Tray The paper is jammed in the MP
tray of the machine.
(See Paper jams on page 80.)
Jam Tray 1
Jam Tray 2
The paper is jammed in the paper
tray of the machine.
(See Paper jams on page 80.)
No Paper The machine is out of paper or
paper is not correctly loaded in
the paper tray.
Do one of the following:
Refill the paper in the paper tray or MP
tray.
Remove the paper and load it again.
No Toner The toner cartridge or the drum
unit and toner cartridge assembly
is not installed correctly.
Re-install the toner cartridge or the drum unit
and toner cartridge assembly.
No Tray The paper tray is not completely
closed.
Close the paper tray properly.
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See
Out of memory message on page 39.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the CD-
ROM.)
Print Unable XX The machine has a mechanical
problem.
Disconnect the machine from the power for
several minutes, then reconnect it.
Protected Device The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Error Message Cause Action