Filter
Top Products
28
CHAPTER FOUR
Setting Volume Amplify
Please carefully read “Setting the Handset Volume” before you do the
following steps:
1
Press
Function
,
1
,
5
.
SELECT <- -> & SET
VOL AMPLIFY:OFF?
2
Press or to select VOL AMPLIFY:OFF? if none of the
users are hearing-impaired and go to Step 4—OR—If some or all of the
users are hearing-impaired, select VOL AMPLIFY:ON?.
SELECT <- -> & SET
PERMANENT?
3
Press or to select PERMANENT? if all the users are
hearing-impaired—OR—Select TEMPORARY? if only some of the
users are hearing-impaired.
4
Press
Set
.
5
Press
Stop
to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your fax machine is onhook (after
you pressed
Hook
), by selecting a speaker volume level.
Press or to adjust the volume level. The display shows the setting
you are choosing. Each key press changes the volume to the next setting.
The new setting will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your fax machine is idle. You can
select a ring volume level or press until the ring is off.
Press or to adjust the volume level. With each key press, the
fax machine rings so you can hear the current setting and the display shows
the setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP, SETUP
RECEIVE and SET AUTO DIAL functions are stored permanently. You
may have to reset the date and time.