Filter
Top Products
4 - 4
INITIAL SETUP
Setting Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting is LOW. When the
beeper is set to LOW or HIGH, the FAX/MFC beeps every time you press a key or
make an error, and at the end of fax sending or receiving.
1
Press Function/Set, 1, 3.
2
Press or to select your setting and press Function/Set.
3
Press Stop to exit.
Choosing the Handset Volume
Before you begin to use the FAX/MFC, you must decide if you need to set the handset
volume to AMPLIFY:ON for a user who is hearing-impaired. The AMPLIFY volume
level complies with FCC standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-impaired. During a
conversation, users can press or on the control panel to adjust the volume.
When the handset is replaced, the handset volume remain until you change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired. During a
conversation, users can press or on the control panel to adjust the volume
to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset volume will
return to the default setting of LOW.
VOL AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY:ON–PERMANENT if all of the users are hearing-impaired.
During a conversation, users can press or on the control panel to adjust the
volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset
volume returns to the default setting of AMPLIFY.
WARNING
It is important that you do not choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the
hearing of some users.
When you press or on the control panel to adjust the volume, the display
shows the setting you are choosing. Each key press changes the volume to the next
setting.