Filter
Top Products
1 - 32 ABOUT THIS PRINTER
6
Press and slide the paper-width guide to fit the envelope size.
Figure 1-39
7
Send the print data to the printer.
8
After you finish the print job, close the back output tray.
DL size double-flap envelopes
■ If the DL size double flap envelope is creased after printing, go to the Basic tab, select Paper
Size and then select DL Long Edge. Put a new DL size double-flap envelope in the MP tray with
the longest edge of the envelope in first, then print again.
When you put envelopes in the MP tray, please remember the following;
■ During printing, the inside tray rises to feed envelopes into the printer.
■ The side to be printed on must be face up.
■ Put the leading edge (top of the paper) in first and push it gently into the tray.
■ The top of the envelope stack must be under the maximum paper height guides that are on both
sides of the tray.
■ If envelopes get smudged during printing, in the printer driver select MP Tray as the Paper
Source for a straight paper path. Then, set the Media Type to Thick Paper or Thicker Paper
to increase the fixing temperature. To adjust the print density setting, see Chapter 3.
■ Envelope joints that are sealed by the manufacturer should be secure.
■ All sides should be properly folded without any wrinkles or creases.