Filter
Top Products
A - 12 APPENDIX A
Connections
The external TAD must be plugged into the back of the MFC, into the
jack labeled EXT. Your MFC cannot work properly if you plug the
TAD into a wall jack (unless you are using Distinctive Ring).
1
Plug the telephone line cord from the telephone wall jack into the
back of the MFC, in the jack labeled LINE.
2
Plug the telephone line cord from your external TAD into the
back of the MFC, in the jack labeled EXT. (Make sure this cord
is connected to the TAD at the TAD’s telephone line jack, and
not its telephone jack.)
3
Set your external TAD to four rings or less. (The MFC’s Ring
Delay setting does not apply.)
4
Record the outgoing message on your external TAD.
5
Set the TAD to answer calls.
6
Set the Receive Mode to
External TAD
.
(See Choosing the Receive Mode on page 4-1.)
Recording outgoing message (OGM) on an external TAD
Timing is important in recording this message. The message sets up
the ways to handle both manual and automatic fax reception.
1
Record 5 seconds of silence at the beginning of your message.
(This allows your MFC time to listen for the fax CNG tones of
automatic transmissions before they stop.)
2
Limit your speaking to 20 seconds.
3
End your 20-second message by giving your Fax Receive Code
for people sending manual faxes. For example:
“After the beep, leave a message or send a fax by pressing
51 and Start.”
We recommend beginning your OGM with an initial 5-second
silence because the MFC cannot hear fax tones over a resonant
or loud voice. You may try omitting this pause, but if your MFC has
trouble receiving, then you must re-record the OGM to include it.