Filter
Top Products
Chapter 11
11 - 3
Machine too Hot The inside of the machine is too hot. Make sure you can hear the fan in the machine
spinning and the exhaust outlet isn’t blocked by
something.
If the fan is spinning, remove any obstacles that
surround the exhuast outlet, and then leave the
machine turned on but do not use it for several
minutes.
If the fan is not spinning, you need to save the faxes
before you follow the suggestions below.
(For FAX-2820, FAX-2910 and MFC-7220)
When you turn off the machine's power switch its
memory will be cleared. To check whether the
machine has faxes in its memory see Checking if the
machine has faxes in its memory on page 11-6. If there
are faxes you need to save them before following the
suggestions below (To save the faxes, see Forwarding
faxes to another fax machine on page 11-6. For
MFC-7220 also see Transferring faxes to your PC
(MFC-7220 and MFC-7225N only) on page 11-6).
Turn off the machine's power switch and then turn it on
again. If the error message continues, leave the
machine for several minutes and try it again.
(For FAX-2920 and MFC-7225N)
Turn off the machine's power switch and then turn it on
again. If the error message continues leave the
machine for several minutes and then try it again. (The
machine can be turned off for up to 4 days without
losing faxes stored in the memory.)
No cartridge The toner cartridge is not installed
properly.
Reinstall the toner cartridge.
No Paper Fed The machine is out of paper or paper is
not properly loaded in the paper tray.
Refill the paper in the paper tray and then press Start.
—OR—
Remove the paper and load it again and then press
Start.
No Response/Busy The number you dialed does not
answer or is busy.
Verify the number and try again.
Not Registered You tried to access a One-Touch or
Speed Dial number that is not
programmed.
Set up the One-Touch or Speed Dial number.
(See Storing One-Touch numbers on page 5-1 and
Storing Speed-Dial numbers on page 5-2.)
ERROR MESSAGES
ERROR MESSAGE CAUSE ACTION