Filter
Top Products
19
On a Macintosh Computer
The Mac version of the software is for a Macintosh with an English operating system. If the
software is installed on a Macintosh with an operating system in a different language, the soft-
ware may not run properly.
BEFORE INSTALLATION
Check that your system configuration meets the following requirements.
Computer: Macintosh with a Power PC processor
Operating system: Mac OS 8.6 or later or OS X 10.1 or later
Hard disk free space: At least 20 MB (100 MB to install full option)
☞ Up to 100 MB of hard disk free space may be needed when printing long labels or large
amounts of data.
Memory: At least 32 MB of available RAM
USB port (installed as standard equipment)
CD-ROM drive
* The application is supplied on a CD-ROM; therefore, the computer should be equipped
with a CD-ROM drive.
INSTALLING THE P-TOUCH EDITOR 3.2 SOFTWARE
The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar-
codes and images, enabling you to design just about any label that you can image. Install the
P-touch Editor 3.2 software onto a Macintosh as described below.
1 With the P-touch 2600/2610 and the Macintosh turned off, connect the P-touch to the
computer using the enclosed USB interface cable as described on page 6. Be sure to
leave the P-touch turned off.
2 Turn on the Macintosh.
3 Insert the enclosed CD-ROM into the com-
puter’s CD-ROM drive.
4 Double-click the Mac OS 9 folder to open
it.
With a Mac OS before OS X: