Brother TD4000 Printer User Manual


 
13
STEP
1
STEP
2
STEP
3
Getting started
Reference Installing the software
Introduction
Die cut label
Continuous length label
If the media does not load properly, trim off some of the media to produce straight
edge and repeat this loading procedure.
5
Position the end of the RD roll to
touch the black plastic cutter guard.
6
Close the RD Roll compartment cover.
7
Press and hold the ON/OFF button ( ) to turn the TD-4000/4100N
on.
8
Press the Feed button.
The printer will position the label to the correct starting position.
You are now ready to print.
8
Press the Feed button twice and the Cut button.
The printer will position the label to the correct starting position.
You are now ready to print.
Black plastic
cutter guard