Filter
Top Products
WBMR-G54 Wireless ADSL Router User Guide
The parameters described in the table below are used to set up filter rules.
Click the Apply button to put the new rule into effect. Any filter rule configured in the menu will appear in the Filters
List with the new settings. The Router must save the new settings and reboot before the new rules are applied.
Filters Parameter Description
Source IP
For an Outbound Filter, this is the IP address or IP addresses on your LAN
for which you are creating the filter rule. For an Inbound Filter, this is the
IP address or IP addresses for which you are creating the filter rule. You
can opt to indicate a
Single IP
, an
IP Range
or
Any IP
from the pull-down
menu. Choosing Any IP will apply the rule to all WAN or all LAN IP
addresses depending on which type of rule (Inbound or Outbound) is being
configured.
Destination IP
Where the Destination IP address resides also depends on if you are
configuring an Inbound or Outbound filter rule. You can opt to indicate a
Single IP
, an
IP Range
or
Any IP
from the pull-down menu.
Source Port
The Source Port is the TCP/UDP port on either the LAN or WAN depending
on if you are configuring an Outbound or Inbound Filter rule. Select one of
the following options from the pull-down menu to define
Any Port, Single
Port
,
Port Range
or
Safe Range
(ports above 1024).
Destination Port
The Destination Port is the TCP/UDP port on either the LAN or WAN
depending on if you are configuring an Outbound or Inbound Filter rule.
Select one of the following options from the pull-down menu to define a
Any Port, Single Port
,
Por Range
or
Safe Range
(ports above 1024).
t
Protocol
Select the transport protocol (
TCP
,
UDP
or
TCP/UDP
) that will be used for
the filter rule.
Action
Select to
Allow
or
Deny
transport of the data packets according to the
criteria defined in the rule. Packets that are allowed are routed to their
destination; packets that are denied are blocked.
65