Filter
Top Products
Initial Configuration
2-6 Vipersat CDM-570/570L User Guide
Figure 2-3
Feature Configuration screen
Figure 2-4
Feature and Unlock Code dialog
Tip: The network administrator will have the feature and unlock codes. These
are stored by the MAC address for the target CDM-570/570L. The target
unit’s MAC address can be found by entering an I and then an E from the
Main Menu shown in figure 2-1.
4. After entering the feature and unlock codes, return to the Feature Config-
uration menu, shown in figure 2-3, and enter V to toggle the Vipersat
Management menu item to Enabled. The unit will automatically reboot in
order to implement the change for this setting.
5. When the reboot is completed, return to the Feature Configuration menu
and configure the settings for Vipersat STDMA and Auto Switching
according to the table below.