Filter
Top Products
Chapter 3 - Using the Command Line Interface (CLI) 3-47
Vipersat Configuration
Transmit Modulation Type
Entering E at the command prompt to use the dialog shown in figure 3-67 to set
the Transmit Modulation Type for the target CDM-570/570L’s home state.
Figure 3-67
Transmit Modulation Type prompt
Transmit Power Level
Enter F at the command prompt to use the dialog shown in Figure 3-68 to set
the Transmit Power Level for the target CDM-570/570L’s home state.
Figure 3-68
Transmit Power Level prompt
Transmit Enable
The modem transmitter can be Enabled or Disabled with this command. Enter G
at the command prompt to toggle the Transmit Enable for the target
CDM-570/570L’s home state between On and Off.
Receive Frequency
Enter M at the command prompt to use the dialog shown in Figure 3-69 to set
the Receive Frequency for the target CDM-570/570L’s home state.
Figure 3-69
Receive Frequency prompt