Filter
Top Products
Bridging
2-98 Using the Novell Translation Window
To access the Novell Translation window from the Bridge Status window:
1. Click on Bridge to display the Bridge menu.
2. Click on Novell Translation. The Novell Translation window, Figure 2-39, will
appear.
To access the Novell Translation window from the Chassis View window:
1. Click on the Board Index of the bridge module of interest; the Board menu
will appear.
2. Click on select Novell Translation. The Novell Translation window,
Figure 2-39, will appear.
Figure 2-39. Novell Translation Window
Translation modes available are:
¥ Data Link Layer Translation
¥ LLC Layer (Logical Link Control) Translation
¥ None
If Data Link Layer Translation is selected, translation is performed within the
data link layer for Novell packets. This translation provides most signiÞcant bit to
least signiÞcant bit conversion on the source/destination MAC addresses located
in the MAC header.
Devices that support Data Link Layer Translation include:
9T125-08
9T125-24
9T425-16
3T0x-04