Filter
Top Products
Chapter 3: ROM Monitor Commands
3-2 CSMIM-T1 Hardware Installation Guide
Table 3-1 ROM Monitor Command
addr [-d]
Displays and sets EEPROM values relevant to network
addressing, including the CSMIM-T1’s Internet address.
boot [-v] [<file>]
Manually boots and loads the CSMIM-T1’s operating
code.
boot [-l] [<file>]
Erases the existing Flash memory and copies a new
image to Flash.
config
Displays the current hardware configuration and
revision levels.
console-baud Changes the console port’s baud rate.
erase Erases non-volatile memory.
help (or “?”) Display the list of ROM Monitor commands.
image [-d/<file>]
Displays and/or sets the load image and TFTP load
dump names.
ipx [-d] Sets IPX load/dump file server.
lat_key [-d] Sets LAT key.
mop [-d] Sets MOP load/dump address.
net
Executes an Ethernet stand-alone external loopback
test.
option_key [-d] Sets or displays the option key.
ping
Sends ICMP ECHO_REQUEST, host [data size]
[npackets].
ports [-d]
Shows the current status of all ports and tests specified
port(s).
sequence
[-d | <list>]
Displays and edits the load/dump interface list.
slip [-d] <port> Configures an SLIP interface.
stats [-slip]
Displays current network statistics gathered by the
ROM.