Filter
Top Products
Chapter 4: CSMIM-T1 Parameters
4-6 CSMIM-T1 Hardware Installation Guide
The reset internal_modem command resets the specified T-1
modem_set. There is no physical reset button. A modem reset forces the
port to be reset. In addition, if the signal protocol is set to wink start or
immediate start, a special AT command is sent to the modem to select the
dialtone detection mechanism.
The
modem_reset parameter specifies the individual modem numbers,
separated by commas, or a range of numbers separated by a hyphen. The
valid modem number range is 1 to 24, inclusive.
Table 4-4 Keywords for the reset t1 Command
Keyword Definition
soft This setting reconfigures the software parameters and will
only disrupt the service on the DS0 channels that are
changed.
hard This setting resets the T-1 engine causing the T-1 Drop/Insert
interface and modem sessions to terminate.
Note: If modem sessions and/or equipment are attached to
the Drop and Insert Interface, their service will be interrupted
for a short period of time (usually a few seconds).
esf This setting resets all the ESF counters in the T-1 engine.