Cabletron Systems ELS10-26TX Switch User Manual


 
2-10
Unpacking and Installing Your ELS10-26
Refer to Section 2.6.3 to make a fiber optic connection to an
FE-100FX.
2.6.1 Connecting UTP Cables
Before connecting a segment to the ELS10-26, check each end of the
segment to verify wire crossover.
Connect a twisted pair segment to the ELS10-26 as follows:
1. Ensure that the device at the other end of the segment is
connected to the segment and is powered ON.
2. Refer to Figure 2-5. Connect the twisted pair segment to the
ELS10-26 by inserting the RJ45 connector on the twisted pair
segment into the desired RJ45 port.
.
Figure 2-5. ELS10-26 Twisted Pair Connection
3. Verify that a Link exists by checking that the port LINK LED is
on (solid green). If the LINK LED is off, perform the following
steps until it is on:
Caution: To establish a link, you must have an odd number of crossovers
(preferably one) between 10BASE-T devices of the same type
(i.e., from repeater to repeater or transceiver to transceiver).
ELS10-26TX
STATUS
PORT STATUS MODE
10BASE-T/
100BASE-TX
FEPIM
2X 4X 6X 8X 10X 12X 14X 16X 18X 20X 22X 24X MONX 26X
27
LINK
STATUS
LINK
STATUS
26
27
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
13
14
15
16
23
24
21
22
17
18
19
20
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
LINK
STATUS
3
4
1
2
7
8
5
6
11
12
9
10
TXACTFDX MON
RXCOL100USR
PWR
CPU
RESET
25
MON
COM