Filter
Top Products
SEH100TX User’s Guide 4-1
CHAPTER 4
INSTALLATION
This chapter outlines the procedure for attaching the SEH to the network
as a stackable or standalone device. Ensure that the network meets the
guidelines and requirements outlined in Chapter 3, Installation
Requirements and Specifications, before installing the SEH.
This chapter covers the following topics:
• Unpacking the SEH (Section 4.1)
• Installing the SEH in a tabletop configuration (Section 4.2)
• Rack Mounting the SEH (Section 4.3)
• Powering Up and Stacking the SEH (Section 4.4)
• Installing Optional EPIMs (Section 4.5)
4.1 UNPACKING THE SEH
Unpack the SEH as follows:
1. Remove the shipping material covering the SEH in the shipping box.
2. Carefully remove the SEH from the shipping box and set it aside to
prevent damage.
3. Visually inspect the SEH. If there are any signs of damage, contact
Cabletron Systems Technical Support immediately. Refer to
Section 1.3, Getting Help, for instructions.
NOTE
A single phase grounded power receptacle that meets the
power supply requirements listed in Chapter 3 must be located
within seven feet of the installation.
Failure to follow installation instructions may result in damage
to the equipment or electrical shock hazard.