Filter
Top Products
Installing an EPIM
SEH100TX User’s Guide 4-9
To install an EPIM-100TX, EPIM-100FX, or EPIM-100FMB, proceed as
follows:
1. Remove the coverplate or the existing EPIM (whichever applies).
2. Slide the new EPIM into place, making sure that the connectors on the
rear of the EPIM align correctly and firmly with the connector inside
the SEH. Refer to Figure 4-6.
3. Tighten the mounting screw.
Figure 4-6 Installing an EPIM
!
CAUTION
When removing an EPIM, pull the module straight out to
prevent damage to the connector.
LNK
EPIM-100TX
EPIM 1
1510_09
LNK
EPIM-100TX
EPIM 2