Filter
Top Products
Installing the WPIM-T1/DDS
WPIM-T1/DDS User’s Guide 2-3
Figure 2-1 Installing the WPIM-T1/DDS
2.1.4 Post-Installation
1. Reinstall the cover as applicable.
2. Refer to the host platform user’s guide to reinstall the network cables
and refer to Appendix A for cabling information for the
WPIM-T1/DDS. Do not connect the WAN cable until instructed to
do so.
3. Refer to instructions contained in the host platform user’s guide to
reapply power.
4. After reapplying power, check the LEDs for the following conditions:
• Verify that the PWR LED is on, indicating that the device is
receiving power.
• After the host platform runs a self test, the CPU LED blinks green
indicating normal operation.
• If the CPU LED remains red, contact Cabletron Systems.
WPIM
WPIM Screws
Standoffs
WPIM
Connector Pins
WPIM
Connector
WPIM-RT1
WPIM
T1/DDS
T1
DDS