Filter
Top Products
Required Operations
WPIM-T1/DDS User’s Guide 2-5
This is done using Network Tools, or MIB Navigator, depending on the
host platform. Refer to the host platform user’s guide for information on
how to navigate through the Local Management screens in order to access
Network Tools.
Follow these steps to configure the WPIM-T1/DDS for T1 or DDS
service:
1. Once in Network Tools, choose between T1 and DDS setup using this
command:
t1dds <SLOT> <T1/DDS>
where SLOT is either 1 for slot one of the host platform for the WPIM,
or 2 for slot two, and T1/DDS is either 1 for DDS service, or 2 for T1
service.
2. Assuming the WPIM-T1/DDS is installed in slot 1, use the following
command to allow the WPIM-T1/DDS in slot 1 to perform T1 service:
t1dds 1 2
To perform DDS service, use the following command, also for slot 1:
t1dds 1 1
3. Press the ENTER key. The unit automatically reboots and the user
must re-enter Local Management.
2.3.2 WAN Configuration
The WPIM-T1/DDS must be configured for WAN operation using either
QuickSET or Local Management before the WAN is connected.
Refer to the QuickSET manual for specific instructions on how to access
the Wide Area configuration for the WPIM-T1/DDS. Refer to Related
Manuals in order to obtain the QuickSET manual.
For Local Management configuration, refer to Chapter 3 for T1
configuration, or Chapter 4 for DDS configuration.
The WAN configuration from QuickSET or either Chapter 3 or Chapter 4
must be completed before proceeding to the next step.