Filter
Top Products
The WAN Physical Configuration Screen
WPIM-RT1 User’s Guide 3-3
2. Use the SPACE bar to select the appropriate WPIM, then press
ENTER. The WAN Configuration screen automatically displays
unique configuration fields for each WPIM as shown in Figure 3-1.
The WAN Physical Configuration screen displays the following
information for each WPIM:
WPIM
1-2
(Read-Only)
Displays configuration information for up to two different WPIMs.
Type (Read-Only)
Displays the type of WPIM installed. For the WPIM-RT1, the Type field
displays T1, for T1 service.
WPIM # (Read-Only)
Displays the number of the slot in which the WPIM resides.
Mgr Type (Selectable)
Used to select the type of protocol manager. The available options are
PPP, FR PtoMP, FR PtoP, HDLC and NONE. The field defaults to NONE.
Max VCs (Modifiable)
Displays the maximum number of virtual circuits (interfaces) available to
be configured. The default number displayed depends on the Protocol
Manager chosen.
Next IF (Read-Only)
Displays the next interface available to be used.
SAVE (Command)
Saves the chosen configuration.
[WPIM X] (Toggle)
Enables the user to select the WPIM to be configured. Once it is selected,
the user can enter the screens of the WPIM selected to modify the data.
WAN INT CONFIG (Command)
When this field is highlighted and the ENTER key is pressed, the WAN
Interface Configuration screen displays. Refer to Section 3.2 for details.
REMOTE SETUP (Command)
Used to access and modify remote profiles information.
RETURN (Command)
Returns user to the previous screen in the hierarchy.