Filter
Top Products
35
Auto PC Adjustment
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Horizontal and Vertical
positions to conform to your computer.
Press the MENU button to display the On-Screen Menu. Use
the Point buttons to move the red frame pointer to the
PC Adjust Menu icon.
1
2
Use the Point ! buttons to move the red frame pointer to
the AUTO PC adj. icon and then press the OK button twice.
PC ADJUST MENU
Auto PC adj.
To store the adjusted parameters.
The adjusted parameters from the Auto PC Adjustment can be stored in
the projector. Once the parameters are stored, the setting can be done
just by selecting Mode in PC SYSTEM Menu (p.34). See MANUAL PC
ADJUSTMENT on pages 36–37.
Note:
• Fine sync, Total dots, Horizontal and Vertical position of certain
computers cannot be fully adjusted with the Auto PC Adjustment
function. When the image is not provided properly with this
operation, manual adjustments are required. (pp. 36–37.)
• Auto PC Adjustment cannot be operated in Digital Signal Input on
the DVI terminal and “480p,” “575p,” “480i,” “575i,” “720p,” “1035i,”
or “1080i” is selected on the PC SYSTEM Menu.
• Depending on the condition of signals and the type and
length of cables, the signals may not be properly viewed.
PC Adjust Menu icon
Move the red frame pointer to the Auto PC
adj. and press the OK button twice.
“Please wait...” appears while the Auto PC
adjustment is in process.
The Auto PC adjustment function can be operated directly
by pressing the AUTO PC button on the remote control unit.
AUTO PC button
Direct Operation
Remote Control Unit
Menu Operation
Computer Input