Filter
Top Products
52
On start
When this function is set to “On,” the projector will be
automatically turned on just by connecting the AC power cord to
the wall outlet.
Note:
• Be sure to turn off the projector properly (see “Turning Off the
Projector” on page 24). If the projector is turned off in the incorrect
sequence, the On start function does not work properly.
Power management
Time left before the lamp is off
Press the OK button at Power
management and the dialog box
appears. Use the Point
buttons to choose one of the three
options.
Press the Point button to select
the timer, and then use the Point
buttons to set the timer
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more
than 30 seconds, the timer display with “No signal” appears. It
starts the countdown until the lamp is turned off. The countdown
time can be set between 1 and 30 minutes.
Use the Point buttons to set the countdown timer.
Select one of the following options:
Ready
.... When the lamp has been fully cooled down, the
POWER indicator starts blinking. In this condition,
the projection lamp is turned on if the input signal
is reconnected or any button on the side control or
remote control unit is pressed .
Shutdown
. . When the lamp has been fully cooled down, the
power is turned off.
Off
....... Power Management function is off.
Power management
The Projector has a USB port for interactive operation between
the projector and computers. Set the mode by following the steps
below.
Wireless Mouse mode
Select “
” when controlling a computer with the remote control
unit of this projector.
Projector mode:
“
” Not used.
USB
Pointer
You can emphasize a part of the projected image with this function.
Use the Point buttons to select a pattern of the Pointer (Arrow,
Cross, or Dot) (P. 30)
Note:
• Factory default is “Ready: 5 min.”
Setting
Note:
• The Point ! buttons and OK button are invalid when the
Pointer function is operating.