Filter
Top Products
51
Lamp mode
Filter control
Choose the running speed of cooling fans from the following
options.
Normal....... Operate in this mode under normal conditions.
Max ........... Use this mode when you want to increase the
cooling effect when operating the projector in high
ambient temperature environment. Fan noise is
lounder than “Normal”.
Fan control
Remote control
Remote control
When pressing the OK button at
Remote control unit, the Remote
control code menu appears.
RC sensor
Select a location of the infrared remote receiver of the remote
control unit. See “Remote Control Receivers and Operating Range”
on page 15 for details.
Both......... Activate both the front and back receiver.
Front........ Activate only the front receiver.
Back......... Activate only the back receiver.
The eight different remote control codes (Code 1–Code 8) are
assigned to the projector; the factory-set, initial code (Code 1) and
the other seven codes (Code 2 to Code 8).
The same code should set on both the projector and the remote
control unit. For example, operating the projector in “Code 7”, the
remote control code also must be switched to “Code 7”.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control unit:
Press and hold the MENU button and a number button (1–8) on
the remote control unit for more than 5 seconds to switch
between the codes (p. 16).
This function allows you to change the brightness of the screen.
You can replace the filter with this function. Press the OK button at
Filter control to display a confirmation box. To replace, press the OK
button at “YES” and the electrically operated filter starts to scroll.
You can also replace the filter by using the remote control unit (p.
29).
Setting
Note:
• Filter replacement icon and “Please wait...”
message appear on the screen when the
filter is being scrolled.
• When the filter is replaced, the total
accumulated time of the filter use is
automatically set to 0
.
Auto mode
......
Brightness according to the input signal.
Normal mode
....
Normal brightness.
Eco 1 mode
.....
Lower brightness and Fan control set to
Normal. Lower brightness reduces the
lamp power consumption and extends the
lamp life.
Eco 2 mode
.....
Lower brightness and Fan control set to
Max. Lower brightness reduces the lamp
power consumption and extends the lamp
life. It is recommended to use Eco 2 mode
when using the projector continuously
over a long period of time. The fan noise
becomes louder in Ecot 2 mode than in
Eco 1 mode. Select the suitalbe mode for
the used environment.