Filter
Top Products
Uploading and Downloading Device Configurations and Images
Issue 1 July 2006 101
Layer 3 Configuration File
The Configuration File feature allows the user to read the routing configuration parameters and
save them to a file on the station. The routing configuration commands in the file are in CLI
format. The user can edit the file (if required) and re-configure the router module by uploading
the configuration file.
Although the file can be edited, it is recommended to keep changes to the file to a minimum.
The recommended configuration method is using C360 Device Manager and/or the CLI.
Changes to the configuration file should be limited to those required to customize a
configuration file from one router to suit another.
Note:
Note: To upload or download Layer 3 configuration files, you must be in a router mode.
Use the CLI commands briefly described below for uploading and downloading Layer 3
configuration files. The rules of syntax and output examples are all set out in detail in the
Reference Guide for the Avaya C360 Converged Stackable Switch, 10-300506.
Display the status of file uploads show upload status
Display the status of file
downloads
show download status
In order to... Use the following command...
2 of 2
In order to... Use the following command...
Download a startup
configuration file to the device
using SCP
copy scp startup-config
Tip:
Tip: To use the startup
configuration file, run the copy
running-config starting-config
command after the
configuration file is
downloaded to the device.
Download a startup
configuration file to the device
using TFTP
copy tftp startup-config
To use the startup configuration file, execute
the copy running-config
starting-config CLI command after the
configuration file is downloaded to the device.
1 of 2