Filter
Top Products
Establishing Switch Access
70 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Establishing Access to Other Entities in the Stack (C360
Sessions)
You can use sessions to switch between the CLI of C360 switches, other stack entities, or to
switch between Layer 2 and Layer 3 commands.
To switch between stack entities use the session [<mod_num>] <mode> CLI command.
● <mod_num> is the number of the switch in the stack, counting from the bottom.
● <mode> can be switch, router, wan, or mgp.
Use switch mode to configure layer 2 commands.
Use router mode to configure routing commands.
Examples:
To configure router parameters in the module that you are currently logged into, type the
following command:
session router
To configure the switch parameters, on switch 6, type the command:
session 6 switch.
Note:
Note: When you use the session CLI command the security level stays the same.