Filter
Top Products
Telnet Client Support
Issue 1 July 2006 109
Telnet Client Support
Introduction to Telnet
The C360 supports invocation of a Telnet client from the CLI. The Telnet client implementation
enables you to control the destination port for connecting daemons that listen on a non-default
port.
Authentication when connecting to the switch via Telnet is identical to standard console
connection authentication (local or RADIUS).
Tip:
Tip: Enabling and disabling the Telnet-client service can only be done using a direct
console connection via the Console port.
By default the Telnet-client service is disabled.
Telnet Commands
The following Telnet commands are available.
For a complete description of the Telnet CLI commands, including syntax and output examples,
refer to the Reference Guide for the Avaya C360 Converged Stackable Switch, 10-300506.
In order to... Use the following command...
Open a Telnet session to
another device.
telnet
Enable Telnet access from the
switch
ip telnet-client enable
Disable Telnet access from the
switch
no ip telnet-client