Filter
Top Products
20
This projector uses nominal input voltages of 100-
240 V AC and it automatically selects the correct
input voltage. It is designed to work with single-
phase power systems having a grounded neutral
conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being
supplied, consult your authorized dealer or service
center.
Connect the projector with all peripheral
equipment before turning the projector on.
:
Unplug the AC power cord when the projector is not in use. When this projector is connected to an outlet with
the AC power cord, it is in Stand-by mode and consumes a little electric power.
Connect the AC power cord
(supplied) to the projector.
To the AC outlet.
To power cord
connector on your
projector.
To the AC outlet.
To the AC outlet.
Ground
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
Ground
The AC outlet must be near this equipment
and must be easily accessible.
Before using the AC Power Cord, attach the ferrite core (supplied) as shown below. (See below for
mounting location.)
The Power Cord with ferrite core must be used for RF interference suppression.
0.39" (10 mm)
AC Power Cord
Ferrite Core
Keep closing until it makes
a clicking sound.