Filter
Top Products
E-89
A Basic DCL Sub-mode Procedure
Example 1: To calculate the degree of combined leverage
(DCL)
1. Input the required values from the Setting Values table
(page E-88).
• For this example, use
fc to select 1 “SAL”,
input 1200000, and then
press E.
• Use fc to select 2 “VC”, input 600000, and then
press E.
• Use fc to select 3 “FC”, input 200000, and then
press E.
• Use fc to select 4 “ITR”, input 100000, and then
press E.
2. Select the value you want to calculate.
• For this example, use
fc to select 5 “DCL”.
3. Press l to perform the
calculation.
A Other DCL Sub-mode Calculations
Example 2: To calculate the sales amount (SAL), variable
cost (VC), fixed cost (FC), and interest (ITR)
• Use the basic procedure (Example 1), substituting the
required values.
A DCL Sub-mode Financial Calculation
Variables (VARS)
•Variables SAL, VC, FC, ITR, and DCL are used in the
DCL sub-mode.
• DCL sub-mode variable contents are cleared whenever
you change to another mode other than the BEVN Mode
sub-modes (BEV, MOS, DOL, DFL, DCL, QTY CONV.).