Filter
Top Products
E-46
k Start, End, and Step Value Rules
• Linear format is always used for value input.
•You can specify either values or calculation expressions (which
must produce a numeric result) for Start, End, and Step.
•Specifying an End value that is less than the Start value causes
an error, so the number table is not generated.
• The specified Start, End, and Step values should produce a
maximum of 30 x-values for the number table being generated.
Executing a number generation table using a Start, End, and Step
value combination that produces more than 30 x-values causes
an error.
Note
•Certain functions and Start, End, Step value combinations can
cause number table generation to take a long time.
k Number Table Screen
The number table screen shows x-values calculated using the
specified Start, End, and Step values, as well as the values obtained
when each x-value is substituted in the function f(x).
•Note that you can use the number table screen for viewing values
only. Table contents cannot be edited.
•Pressing the A key returns to the function editor screen.
k TABLE Mode Precautions
Note that changing the input/output format settings (Math format or
Linear format) on the calculator’s setup screen while in the TABLE
Mode clears the number table generation function.
Technical Information
k Calculation Priority Sequence
The calculator performs calculations according to a calculation priority sequence.
• Basically, calculations are performed from left to right.
•Expressions within parentheses have the highest priority.
• The following shows the priority sequence for each individual command.
1. Function with parentheses:
Pol(, Rec(
sin(, cos(, tan(, sin
–1
(, cos
–1
(, tan
–1
(, sinh(, cosh(, tanh(, sinh
–1
(, cosh
–1
(,
tanh
–1
(
log(, ln(, e^(, 10^(, '(,
3
'(
Abs(
Rnd(
2. Functions preceded by values, powers, power roots:
x
2
, x
3
, x
–1
, x!, ° ’ ”, °,
r
,
g
, ^(,
x
'(
Percent %
3. Fractions: a
b
/c