Filter
Top Products
16
E
Getting Started
X1
Z1
X2/Z2
REG2
REG1
OFF
RF
PGM
Mode Switch
3s
8
: : : :
s
8
: :
^
: : : :
a
8
: : : :
a
8
: : : :
a
8
: : : :
a
8
: : : :
a
8
: : : :
a
8
: : : :
a
8
s
0125
0225
0325
0425
{
Tax table 1 =
Tax table 2 =
Tax table 3 =
Tax table 4 =
Tax rate (4-digit for integer + 4-digit for decimal)
Tax table maximum value (“0” means unlimited).
Rounding/tax table system code
*1
Sum of a cyclic pattern
Number of values in each cyclic pattern
Number of values in each non-cyclic pattern
*1
Rounding/tax table system code
Loop to input the next block.
Actual value of difference of the non-cyclic and cyclic values
You must enter these values in 4-digit block. If the last block
comes out to be only two digits, add two zeros.
D
1
D
2
D
3
D
4
D
3
0
0
0
D
4
5
9
0
Rounding code specification
Tax system code specification
Rounding
Rounding off two decimal places
Rounding up to two decimal places
Cut off to two decimal places
D
1
1
2
3
4
D
2
0
0
0
0
Rounding
Tax table only
U.S. tax table with tax rate or add-on
tax rate only
Add-in tax rate
Canadian tax system (Tax-on-tax)
Canadian tax system
For both add-on and add-in tax systems.
To program Tax-on-tax system, you must use the tax address “0225”, “0325” or “0425.”
(only for Canada)
Programming procedure
Tax table programming
Important!
After you program the tax tables, you also have to individually specify which departments (page 36)
and PLUs (page 39) are to be taxed.
For this cash register to be able to automatically register state sales tax, you must program
its tax tables with tax calculation data from the tax table for your state. There are three (U.S.)/
four (Canada) tax tables that you can program for automatic calculation of separate sales
taxes.
10.