Casio XJ-S41 Projector User Manual


 
E-34
Troubleshooting
The status of the indicators lets you know the current operational status of the projector. This
section provides details about indicators.
z “POWER” in the following table stands for the “POWER/STANDBY” indicator.
Normal Operation Indicators
Error Indicators and Warning Messages
When an error occurs, wait until cool down is complete and the fan stops before unplugging the
AC power cord. If you unplug the AC power cord while the fan is still operating, an error may
occur when you plug the AC power cord back in.
Indicators
When this indicator: Is this: It means this:
POWER : Amber steady
You have just plugged the AC power cord into a power
outlet. Wait until the projector enters the standby state
(see below) before trying to turn on power.
TEMP : Amber steady
LAMP : Amber steady
POWER : Amber steady
Standby state: The AC power cord is plugged in and
the projector is in standby.
POWER : Green flashing Projector is warming up after being turned on.
POWER : Green steady Projector is on and standing by for use.
POWER : Amber flashing
Projector is cooling down after being turned off. If the
projector is hot when you plug the AC power cord into
a power outlet, it also goes into a cool down state.
LAMP : Green steady The projector’s Eco Mode is turned on.
Indicator/Error Message Description and Required Action
POWER
TEMP
LAMP
: Green steady
:–
:–
The projector’s internal temperature is very high. Press the
[ESC] key to clear the warning message and perform the
following steps.
1 Check for any blocking of the projector’s intake vents and
exhaust vents, and make sure that there is sufficient space
around the projector. See
Setup Precautions” (page E-15).
2 If there is dust accumulated around the intake vents and/or
exhaust vents, turn off the projector and remove it. See
Cleaning the Projector” (page E-27).
Message : Internal temperature
is too high. Check
projector air vents for
blockage.
LAMP indicator
POWER/STANDBY indicator
TEMP indicator