Filter
Top Products
21
The presentation timer shows the amount of presentation timing remaining. You can configure the
presentation times so it is displayed in the projected image.
To specify timer display position and countdown time settings
1.
Press the [TIMER] key.
z This will cause the timer to appear in the projected image. The initial default display position is
the lower right corner of the image.
2.
While the timer is displayed, press the [TIMER] key again.
z This will cause the timer to disappear and the timer function menu to appear.
3.
Use the [T] key to select “Position”.
4.
Use the [W] and [X] keys to change the setting to the display position you want.
z Available settings are Lower Right, Upper Right, Upper Left, and Lower Left. The initial default
position is Lower Right.
5.
Use the [T] key to select “Start Time”.
6.
Use the [
W
] and [
X
] keys to change the setting to the countdown start time you want.
z You can set a start time from five to 60 minutes, in five-minute steps. The initial default setting
is 20 minutes.
7.
After the settings are the way you want, press the [ESC] key.
z This will cause the timer function menu to disappear. The timer will appear in the projected
image for about five seconds and then disappear (under initial settings).
z If you want the timer to remain displayed without disappearing, change the “Continuous
Display” setting to “On”.
z Even if “Continuous Display” is “On”, you can clear the timer from the image at any time by
pressing [ESC]. The timer will also disappear when you display a menu or a dialog box. To
re-display the timer after it has disappeared, press [TIMER].
Presentation Timer
Timer
B