Filter
Top Products
35
Image Adjustment 2 Main Menu
About the “Signal Specific” Setting Unit
For the items that have “Signal Specific” in the “Setting Unit” column of the above table, the setting is
saved for the specific type of signal (XGA/60Hz, SXGA/60Hz, etc.) that is being input when the setting
is performed, and not for a specific input source.
Volume Adjustment Main Menu
Setting Name Input Setting Unit Description
Vertical
Position
RCV
Signal
Specific
Use this sub-menu to adjust the vertical position of the input
source image within the projection area.
Horizontal
Position
RCV
Signal
Specific
Use this sub-menu to adjust the horizontal position of the input
source image within the projection area.
Frequency
R
Signal
Specific
When vertical bands appear in the projected image while RGB is
selected as the input source, it means that the frequency setting is
not correct. When this happens, use this setting to adjust the
frequency manually.
Important!
If, for some reason, your manual frequency settings cause
the image input from the computer to disappear from the
projection, you can press the [AUTO] key to perform an auto
adjust operation, which should cause the image to appear.
Phase
R
Signal
Specific
When there is flickering in the projected image while RGB is
selected as the input source, it means that the phase setting is not
correct. When this happens, use this setting to adjust the phase
manually.
Restore Menu
Defaults
RCV
Source
Specific
Use this sub-menu to return all of the sub-menu items on the
Image Adjustment 2 main menu to their initial default settings.
z Restoring menu defaults will restore defaults for the current
signal type (XGA/60Hz, SXGA/60Hz, etc.) only.
Setting Name Input Setting Unit Description
Volume
RCVHDWUN
Source
Specific
*1
Use this sub-menu to adjust the volume level of the projector’s
speaker or the AV terminal.
z Changing this setting when there is no input signal changes the
volume setting of the currently selected signal source.
Restore Menu
Defaults
RCVHDWUN
Source
Specific
*1
Use this sub-menu to return Volume to its initial default setting.
z Restoring menu defaults when there is no input signal will
restore defaults for the currently selected input source.
*1 The same setting value is saved for both wireless LAN input (W) and USB input (U).
B