Filter
Top Products
Installing the Router
2-11
The router recognizes all SCSI devices connected to the three SCSI channels on the
VFS113, and assigns each device a unique LUN address, which will be mapped as part of
a unique FC address. You can configure the router to assign itself a LUN for in-band
management, server-free backup, and other uses.
To make the host FC connection:
1 Connect the Fibre Channel cable to the router and the host computer, hub, or switch.
2 Power up connected servers, hubs, or switches on the network if necessary.
You are now ready to configure the router. To view the default settings, see Router Default
Settings on page 2-12. For information about changing the default settings, see Chapter 3,
Configuring the Router.
Understanding the LED Status Lights
LED status lights are on the rear panel of the router. For information about troubleshooting
problems indicated by the status lights, see Chapter 4, Troubleshooting.
Figure 2-11. LED status lights
Table 2-12 describes the meaning of the LED status lights located on the rear of the router.
Table 2-12. LED status lights
LED
Label Description Color Function
FT Router fault Red Solid on when router is powered-up
and fails any internal diagnostic or
detects a critical error
ST Router status Yellow Solid on when router is powered-up
and passes all internal diagnostics
Yellow Off when router either:
■ Detects a warning/degraded mode
■ Fails to boot
FC Host FC activity Green Solid on when FC link is connected
Solid off when FC link is
disconnected