Filter
Top Products
Configuring the Router
3-27
Displaying Hardware and Configuration Information
You can display the router’s hardware and configuration information. This is where you
can see what version of the firmware you have. Chaparral technical support personnel may
also request this information.
You can display the hardware and configuration information two ways:
■ Hardware information only
■ Hardware and configuration information
Table 3-4 lists the configuration information that is available.
Table 3-4. Configuration information
Group Field What displays Field What displays
HOST Topology Loop or Point-to-Point
based on the topology
set in the Router
Administrator software.
If set to Loop, the router
detects if it is attached
to a public loop (router
is attached to the FL-
port of a switch) or a
private loop.
Node WWN FC World Wide Name
for node.
Port WWN FC World Wide Name
for port.
FC Addr 24-bit FC address or
None if the FC link is
not active.
AL_PA, if
the
topology is
LOOP.
Currently assigned
value or None if the
FC link is not
active.
Loop ID, if the
topology is
LOOP.
SOFT or a specific
number as set in the
Router Administrator
software.
Current Currently assigned
value if the
topology is LOOP,
or Inactive if the FC
link is not active.
Router LUN SOFT, NONE, or
specific number as set in
the Router
Administrator software.
Current Currently assigned
value or Inactive if
the Router LUN is
set to NONE.
CHAN 0
CHAN 1
CHAN 2
Initiator ID SCSI ID of router on
Channel 0 as set in the
Router Administrator
software.
Ultra/U2 Hardware runs as
Ultra2.
Termination Hardware setting: ON
or OFF.
Term
Power
Hardware supplies
termination power.