Filter
Top Products
Section 4: OPERATION
GS Series User Manual
020-000724-01 Rev. 1 (05-2014)
4-11
Menu Preferences
• Menu Horz Position: Change the horizontal position of the OSD.
• Menu Vert Position: Change the vertical position of the OSD.
• Show Messages: Display status messages on the screen.
• Menu Transparency: Change OSD menu background to be transparent.
NOTE:
As the value increases, more of the image behind the menu is visible.
• Splash Screen: Choose which splash screen is to be used.
• PIN Protect: The PIN (personal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you
must enter the PIN before you can project an image.
• Change PIN: Allows you to change the PIN.
Power Management
• Standby Mode: The projector is in standby mode when connected to AC
• power. (<0.5W)
• AC Power On: The projector automatically turns on when electrical power
is connected.
• Auto Shutdown: Automatically turns the projector off after no signals are
detected for a preset number of minutes. If an active signal is received
before the projector powers down, the image will be displayed.
• Sleep Timer: Allows the projector to automatically power off after it has
been on for a specified amount of time.
High Altitude
Set high altitude mode ON/OFF.When ON, the fan will operate at high speed
to ensure sufficient air flow for high altitudes.
Communications
• Network: Allow you to setup network settings.
- DHCP: Turn the DHCP ON/OFF.
- IP Address: Assign Network IP Address.
- Subnet Mask: Assign Network Subnet Mask.
- Default Gateway: Assign Network Default Gateway.
- Host Name: Display the host name.
- MAC Address: Displays network MAC Address value.
- Show Network Messages: Turn network messages ON/OFF.
- Restart Network: Restart the network.
- Network Factory Reset: Perform factory reset on the network settings.
The Projector Name, LAN IP, WLAN IP, and SNMP settings will be
reset.
• Baud Rate: Select the serial port and baud rate.