Section 1: SAFETY
GS Series User Manual
020-000724-01 Rev. 1 (05-2014)
1-1
1. SAFETY
Read through this document in its entirety and understand all warnings and
precautions before attempting to operate the projector.
WARNING
.
• Do not look into the projector lens when the laser is on. The bright light
may result in permanent eye damage.
• To reduce the risk of fire or electric shock, do not expose this projector to
rain or moisture.
• Do not open or disassemble the projector as this may cause electric shock.
• All installation and maintenance procedures must be performed by a
Christie accredited service technician.
• Keep all combustible material away from the concentrated light beam of
the projector.
• Position all cables where they cannot contact hot surfaces or be pulled or
tripped over.
• Always power down the projector and disconnect all power sources before
servicing or cleaning.
• Use a soft cloth moistened with a mild detergent to clean the display
housing.
• Disconnect the power plug from the AC outlet if the product is not being
used for an extended period of time.
• Operate the projector under the following conditions:
- Operating temperature range: 5°C to 35°C
- Storage temperature range: -10°C to 60°C
- Humidity range: 5% to 80 % RH (Max.), non condensing
- Operating altitude: 10,000 ft. maximum
• Use only the AC power cord supplied. Do not attempt operation if the AC
supply and cord are not within the specified voltage and power range for
your region.
• Remove the lens plug from the lens opening in the projector before
installing the lens. Retain the lens plug to protect the optical components
from dust and debris during transport.
• Do not block the ventilation slots and openings on the projector.
• Do not use abrasive cleaners, waxes or solvents to clean the projector.
• Do not allow anything to rest on the power cord.