Filter
Top Products
6
22. Center the heat shrink tubing (2) over the solder joint
and heat using a heat gun. Heat the joint until the tub
ing is tightly sealed and sealant (1) comes out of both
ends of the tubing.
NOTE: Driver side shown, passenger similar.
23. Position the passenger side cowl trim panel to the ve
hicle.
24. Hand press the passenger side cowl trim panel to the
corresponding holes in sheet metal (2).
25. Place the passenger side door sill trim panel (3) and
(5) into position.
26. Align locator tab to the locator slot in door sill (2).
27. Pushing downward on passenger side sill trim panel
to engage tabs the attaching clips to the door sill.
Feb 12, 2010 K6860899 Rev. 2