Filter
Top Products
4
NOTE: Make sure enough wire length is supplied to go into the load floor where the WiFi router (1) will be
located.
17. Route and secure the WiFi power harness from rear
quarter panel, along the passenger side and under
neath the door sill scuff plate.
18. Route and secure the power harness under the glove
box and behind the center stack.
NOTE: Do not use the power outlet wiring for the WiFi
Router.
19. Locate the cigarette lighter outlet wiring harness.
20. Splice the supplied fused pigtail (2) into the cigarette
lighter power wire and in series with the WiFi power
harness.
21. Remove 13 mm (0.5 in.) of insulation from each wire
that needs to be spliced.
22. Place a piece of adhesive lined heat shrink tubing on
one side of the wire. Make sure the tubing will be long
enough to cover and seal the entire repair area.
23. Place the strands of wire overlapping each other in
side of the splice clip (1).
Oct 16, 2009 K6860899 Rev. 1