Filter
Top Products
2
6. Secure the WiFi router bracket (1) under the passen
ger seat with the provided materials.
7. Connect the power harness connector (2) to the WiFi
router.
NOTE: Do not use the power outlet for the power supply to the WiFi router.
8. Locate the cigarette lighter outlet wiring harness.
9. Cut each wire and remove 13 mm (0.5 in.) of insula
tion from each wire that needs to be soldered/spliced.
10. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol
dered area.
CAUTION: Do not use acid core solder.
11. Solder the supplied fused pigtail to WiFi power har
ness power wire.
12. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009 K6860899 Rev. 1