Filter
Top Products
Using Your Hub Software 3-17
User Interface Commands
Administrator Password Commands
Use the commands in this section to configure hub passwords.
password
no password
Syntax: password
Mode: Administrator
Description: Configures the password used to enter administrator mode.
After entering the command, you will be prompted to enter the current
password and then the new password. You will then be prompted to confirm the
new password. Password characters are represented by asterisks on the screen
when you enter them, as shown below:
Hub# password
Old password: ********
New password: *******
Re-type new password: *******
Passwords can:
• Contain up to 14 characters.
• Contains any combination of alphanumeric characters, including uppercase
and lowercase letters.
• Use spaces as valid characters.
Syntax: no password
Mode: Administrator
Description: Deletes any password that has been set with the password command.