Filter
Top Products
Using Your Hub Software 3-21
Firmware Load and Restart Commands
Firmware Load and Restart Commands
Use the commands in this section to configure how the hub loads and copies firmware.
Bootup Option Commands
Use the commands in this section to configure how the hub gets the firmware and IP address
when it is first powered up.
bootup-option
no bootup-option
Syntax: bootup-option {normal | tftp-download | bootp-get-ip | bootp-download}
Mode: Administrator
Description: Configures how the hub will obtain an IP address when it is first turned on.
This setting is stored in the hub Flash read-only memory.
Command Keyword Definitions
• normal—Default setting for the Micro Hub 1502. The hub uses the IP
address stored in the onboard firmware.
• tftp-download—Downloads firmware from a TFTP server. The download
process is repeated every time the hub is rebooted.
• bootp-get-ip—Default setting for the Micro Hub 1503. The hub obtains the
IP address from the local BOOTP server.
• bootp-download—The hub obtains the IP address and firmware from a
local BOOTP server. The firmware is then saved in Flash memory.
Syntax: no bootup-option
Mode: Administrator
Description: Resets the hub to the default bootup option, which is to use the onboard ROM
code and the default IP address (normal).