Filter
Top Products
15
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
78-13892-03
March 2002
Internal CompactFlash Memory Card Installation and Removal
Figure 13 Inserting Plug-in CPU/Mainboard into a Cisco 3745 Chassis
Step 3
Tighten the two captive retention screws; there is one at each edge of the CPU/mainboard.
Step 4 Hold the front panel straight out from the chassis, engage the hinges, and close the front panel. (See
Figure 14.)
Step 5 Tighten the two captive screws behind the small access panel at the right-hand edge.
Step 6 Power ON the router.
Observe the following precaution if your router uses DC power:
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position. To see translations
of the various warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
62489
Captive
retention
screw
Ejector levers
Captive
retention
screw