Filter
Top Products
D-3
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Appendix D Using the Configuration/Setup Utility Program
Configuration/Setup Utility Menu Options
System Information
Choose this option to view information about your device. When you make
changes through other options in the Configuration/Setup Utility program, some
of those changes are reflected in the system information; you cannot change
settings directly in the system information.
This option is on the full Configuration/Setup Utility menu only.
Product Data
Choose this option to view the machine type and model of your device, the serial
number, and the revision level or issue date of the BIOS code stored in electrically
erasable programmable ROM (EEPROM).
Devices and I/O Ports
Choose this option to view or change assignments for devices and input/output
(I/O) ports.
Choose this option to enable or disable integrated SCSI and Ethernet controllers
and all standard ports (such as serial and parallel). If you disable a device, it
cannot be configured, and the operating system will not be able to detect it (this
is equivalent to disconnecting the device). If you disable the integrated Ethernet
controller and no Ethernet adapter is installed, the device will have no Ethernet
capability. If you disable the integrated USB controller, the device will have no
USB capability; to maintain USB capability, make sure that Enabled is selected
for the USB Host Controller and USB BIOS Legacy Support options.
This option is on the full Configuration/Setup Utility menu only.
Start Options
Choose this option to view or change the start options. Startup sequences take
effect when you start the device. The startup sequence specifies the order in which
the device checks devices to find a boot record. The device starts from the first
boot record that it finds.
This option is on the full Configuration/Setup Utility menu only.
Date and Time
Choose this option to set the date and time in the device, in 24-hour format
(hour:minute:second). This option is on the full Configuration/Setup Utility menu
only.