Filter
Top Products
Chapter 4 Installing Hardware Options
Completing the Installation
4-18
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
To install the cover and bezel, follow these steps:
Step 1 Install the cover by placing it into position and sliding it forward, and then tighten
the captive screws (labeled 1 in Figure 4-8).
Caution Before sliding the cover forward, make sure that the cover will properly engage
the ledge at the front of the device.
Step 2 Install the bezel:
a. Align the hooks on the bottom of the bezel with the device.
b. Press the bezel toward the device until it clicks into place.
Figure 4-8 Installing the Cover
115802
1