Filter
Top Products
Configuring Source-Route Bridging BC-109
Configuring Source-Route Bridging
This chapter describes source-route bridging (SRB) configuration tasks. For a discussion of remote
source-route bridging (RSRB) configuration tasks, refer to the “Configuring Remote Source-Route
Bridging” chapter in this publication.
For a complete description of the SRB commands mentioned in this chapter, refer to the
“Source-Route Bridging Commands” chapter in the Bridging and IBM Networking Command
Reference. To locate documentation of other commands that appear in this chapter, use the command
reference master index or search online.
SRB Configuration Task List
Perform the tasks in the following sections to configure SRB:
• Configure Source-Route Bridging
• Configure Bridging of Routed Protocols
• Configure Translation between SRB and Transparent Bridging Environments
• Configure NetBIOS Support
• Configure LNM Support
• Secure the SRB Network
• Tune the SRB Network
• Establish SRB Interoperability with Specific Token Ring Implementations
• Monitor and Maintain the SRB Network
See the end of this chapter for “SRB Configuration Examples.”
Warning The Cisco IOS software issues a warning if a duplicate bridge definition exists in a router. You
must remove an old bridge definition before adding a new bridge definition to a router configuration.