Filter
Top Products
Configuring Data-Link Switching Plus
DLSw+ Configuration Task List
BC-290
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
TCP/IP with RIF Passthrough Encapsulation
To configure TCP/IP with RIF Passthrough encapsulation, use the following command in global
configuration mode:
The following command specifies a remote peer with TCP/IP with RIF Passthrough encapsulation:
dlsw remote-peer 0 tcp 10.2.23.5 rif-passthru 100
FST Encapsulation
To configure FST encapsulation on a remote peer, use the following command in global configuration
mode:
The following command specifies a DLSw remote peer with FST encapsulation:
dlsw remote-peer 0 fst 10.2.23.5
Command Purpose
Router(config)# dlsw remote-peer list-number tcp
ip-address [backup-peer [ip-address |
frame-relay interface serial number dlci-number
|
interface name]] [bytes-netbios-out
bytes-list-name] [circuit-weight weight] [cost
cost] [dest-mac mac-address] [dmac-output-list
access-list-number] [host-netbios-out
host-list-name] [inactivity] [dynamic]
[keepalive seconds] [lf size] [linger minutes]
[lsap-output-list list] [no-llc minutes]
[passive] [priority] [rif-passthru
virtual-ring-number] [tcp-queue-max size]
[timeout seconds]
Defines a remote peer with TCP/IP with RIF Passthrough
encapsulation.
Command Purpose
Router(config)# dlsw remote-peer list-number fst
ip-address [backup-peer [ip-address |
frame-relay interface serial number dlci-number
| interface name]]
[bytes-netbios-out bytes-list-name]
[circuit-weight weight] [cost cost] [dest-mac
mac-address] [dmac-output-list
access-list-number] [host-netbios-out
host-list-name] [keepalive seconds] [lf size]
[linger minutes] [lsap-output-list list]
Defines a remote peer with FST encapsulation.